GL Base Switch Spacer

$12.50 USD
Type: Base
Sets

for GL Base Variable Spacing only, it allow tuners positioning the switch individually to adjust sensitivity for each directions.

there 5pcs basic spacing :
15mm
15.5mm (one notch spacer)
16mm (two notch spacer)
16.5mm (three notch spacer)
17mm (four notch spacer)
and 2pcs alternate spacing :
+ Tilt (positive)
- Tilt (negative)

Always double check your spacing and  actuator combination, make sure the actuation not bending the switch hinge/blade on full throw.

*All necessary screws are included on every GL base.

When adjusting the switches you don't need to unscrew completely, because the nut inside the base can be out of place and you will need to open the base to fix it. Just make 360 rotation counter clock to loose the screw until switches can move, then it is ready for adjustment.

When fixing the screw after adjustment never do overtight, it can damage the base and makes difficult to remove the screw, just put enough tension to keep the switch in place when actuate. Some tips, tighten it using thumb and pointing finger only when holding screwdriver to reduce overtighten risk.